Activity

This present study was to identify a novel candidate gene that contributes to the elevated α-linolenic acid (ALA, ω-3) concentration in PE2166 from mutagenesis of Pungsannamul. Major loci qALA5_1 and qALA5_2 were detected on chromosome 5 of soybean through quantitative trait loci mapping analyses of recombinant inbred lines. With next-generation sequencing of parental lines and Pungsannamul and recombinant analyses, a potential gene, Glyma.05g221500 (HD), controlling elevated ALA concentration was identified. HD is a homeodomain-like transcriptional regulator that may regulate the expression level of microsomal ω-3 fatty acid desaturase (FAD3) genes responsible for the conversion of linoleic acid into ALA in the fatty acid biosynthetic pathway. In addition, we hypothesized that a combination of mutant alleles, HD, and either of microsomal delta-12 fatty acid desaturase 2-1 (FAD2-1) could reduce the ω-6/ω-3 ratio. In populations where HD, FAD2-1A, and FAD2-1B genes were segregated, a combination of a hd allele from PE2166 and either of the variant FAD2-1 alleles was sufficient to reduce the ω-6/ω-3 ratio in seeds.Since the optical and electrical properties of organic thin films devices depend on their supramolecular arrangement and the molecular chemical structure, the understanding of such characteristics is essential for the optimization of these devices. In this study, we determine the supramolecular arrangement of thin films produced using the Langmuir-Schaefer (LS) technique and explain how its supramolecular arrangement is affected by the molecular chemical structure using two perylene derivatives bis-butylimide (BuPTCD) and bis-phenethylimide (PhPTCD). The optical absorption measurements reveal that both films grow homogeneously and indicate that the presence of H aggregates (forbidden emission) is higher for BuPTCD LS film than for PhPTCD LS film. Atomic force microscopic analysis shows that the PhPTCD LS film is rougher than the BuPTCD film. In addition, FTIR analyses indicate that both films have head-on molecular organization. XRD patterns reveal that both the BuPTCD LS film and the PhPTCD LS film are crystalline, but that crystallinity is more prevalent in the BuPTCD LS film. Thus, the results show that the difference presented in the chemical structures leads the films to have different supramolecular arrangements, with consequences for their optical properties.Indirect detection of Porphyromonas gingivalis in saliva, based on proteolytic cleavage by an Arg-specific gingipain (Arg-gingipain), has traditionally been used for simple, initial diagnosis of periodontitis. To accurately detect P. gingivalis using a point-of-care format, development of a simple biosensor that can measure the exact concentration of P. gingivalis is required. However, electrochemical detection in saliva is challenging due to the presence of various interfering electroactive species in different concentrations. Here, we report a washing- and separation-free electrochemical biosensor for sensitive detection of P. gingivalis in saliva. Glycine-proline-arginine conjugated with 4-aminophenol (AP) was used as an electrochemical substrate for a trypsin-like Arg-gingipain, and glycylglycine was used to increase the Arg-gingipain activity. The electrochemical signal of AP was increased using electrochemical-chemical (EC) redox cycling involving an electrode, AP, and tris(2-carboxyethyl)phosphine, and the electrochemical charge signal was corrected using the initial charge obtained before a 15 min incubation period. The EC redox cycling combined with the matrix-corrected signal facilitated a high and reproducible signal without requiring washing and separation steps. The proteolytic cleavage of the electrochemical substrate was specific to P. gingivalis. The calculated detection limit for P. gingivalis in artificial saliva was 5 × 105 colony-forming units/mL, and the concentration of P. gingivalis in human saliva could be measured. The developed biosensor can be used as an initial diagnosis method to distinguish between healthy people and patients with periodontal diseases.The effects of flagella and their properties on bacterial transport and deposition behaviors were examined by using four types of Escherichia coli (E. coli) with or without flagella, as well as with normal or sticky flagella. Packed column, quartz crystal microbalance with dissipation, visible parallel-plate flow chamber system, and visible flow chamber packed with porous media system were employed to investigate the deposition mechanisms of bacteria with different properties of flagella. CCS-1477 We found that the presence of flagella favored E. coli deposition onto quartz sand/silica surfaces. Moreover, by changing the porous media porosity and directly observing the bacterial deposition process, local sites with high roughness, narrow flow channels, and grain-to-grain contacts were found to be the major sites for bacterial deposition. Particularly, flagella could help bacteria swim near and then deposit at these sites. In addition, we found that due to the stronger adhesive forces, sticky flagella could further enhance bacterial deposition onto quartz sand/silica surfaces. Elution experiments indicated that flagella could help bacteria attach onto sand surfaces more irreversibly. Clearly, flagella and their properties would have obvious impacts on the transport/deposition behaviors of bacteria in porous media.Copper chalcogenide nanocrystals find applications in photovoltaic inks, bio labels, and thermoelectric materials. We reveal insights in the nucleation and growth during synthesis of anisotropic Cu2ZnSnS4 nanocrystals by simultaneously performing in situ X-ray absorption spectroscopy (XAS) and small-angle X-ray scattering (SAXS). Real-time XAFS reveals that upon thiol injection into the reaction flask, a key copper thiolate intermediate species is formed within fractions of seconds, which decomposes further within a narrow temperature and time window to form copper sulfide nanocrystals. These nanocrystals convert into Cu2ZnSnS4 nanorods by sequentially incorporating Sn and Zn. Real-time SAXS and ex situ TEM of aliquots corroborate these findings. Our work demonstrates how combined in situ X-ray absorption and small-angle X-ray scattering enables the understanding of mechanistic pathways in colloidal nanocrystal formation.