Activity

It is shown that the PA technique has become a powerful and efficient tool in the following areas, including but not limited to materials synthesis, doping, surface modification, and functionalization. Finally, the prospect and challenges are also proposed for AEM preparation and modification using PA systems. This article aims to provide up-to-date information about the progress of PA technology in the fields of chemistry and materials science.Reduced graphene oxide and molybdenum disulfide (rGOMoS2) are the most representative two-dimensional materials, which are promising for a humidity sensor owing to its high surface area, a large number of active sites, and excellent mechanical flexibility. Herein, we introduced a highly sensitive and stable rGOMoS2-based humidity sensor integrated with a low-power in-plane microheater and a temperature sensor, directly insertable to transformer insulating oil, and analyzed by a newly developed customized sensor interface electronics to monitor the sensor’s output variations in terms of relative humidity (RH) concentration. rGOMoS2 sensing materials were synthesized by simple ultrasonication without using any additives or additional heating and selectively deposited on titanium/platinum (Ti/Pt) interdigitated electrodes on a SiO2 substrate using the drop-casting method. The significant sensing capability of p-n heterojunction formation between rGO and MoS2 was observed both in the air and transformer insulating oil environment. In air testing, the sensor exhibited an immense sensitivity of 0.973 kΩ/%RH and excellent linearity of ∼0.98 with a change of humidity from 30 to 73 %RH, and a constant resistance deviation with an inaccuracy rate of 0.13% over 400 h of continual measurements. In oil, the sensor showed a high sensitivity of 1.596 kΩ/%RH and stable repeatability for an RH concentration range between 34 and 63 %RH. The obtained results via the sensor interface were very similar to those measured with a digital multimeter, denoting that our developed total sensor system is a very promising candidate for real-time monitoring of the operational status of power transformers.Enzyme-linked immunosorbent assays (ELISAs) are used extensively for the detection and quantification of biomolecules in clinical diagnostics as well as in basic research. Although broadly used, the inherent complexities of ELISAs preclude their utility for straightforward point-of-need testing, where speed and simplicity are essential. With this in mind, we developed a bioluminescence-based immunoassay format that provides a sensitive and simple method for detecting biomolecules in clinical samples. We utilized a ternary, split-NanoLuc luciferase complementation reporter consisting of two small peptides (11mer, 13mer) and a 17 kDa polypeptide combined with a luminogenic substrate to create a complete, shelf-stable add-and-read assay detection reagent. Directed evolution was used to optimize reporter constituent sequences to impart chemical and thermal stability, as well as solubility, while formulation optimization was applied to stabilize an all-in-one reagent that can be reconstituted in aqueous buffers or sample matrices. The result of these efforts is a robust, first-generation bioluminescence-based homogenous immunoassay reporter platform where all assay components can be configured into a stable lyophilized cake, supporting homogeneous, rapid, and sensitive one-step biomolecule quantification in complex human samples. This technology represents a promising alternative immunoassay format with significant potential to bring critical diagnostic molecular detection testing closer to the point-of-need.Highly soluble d8-d10 heteronuclear phosphors afford an alternative approach to achieve high-efficiency organic light-emitting diodes (OLEDs) through a solution process. In this work, four highly phosphorescent d8-d10 heteronuclear complexes with significant Pt-Au interactions were prepared. By judicious selection of sterically hindered and π-conjugated substituents in triphosphine ligands, the phosphorescence is dramatically promoted through effectively prohibiting nonradiative thermal relaxation with an efficiency of 0.94-0.99 in doping films. Exploiting highly emissive Pt-Au complexes as phosphorescent dopants, ultrahigh-efficiency solution-processed OLEDs were attained. The peak current efficiency, power efficiency, and external quantum efficiency are 96.2 cd A-1, 65.0 lm W-1, and 26.4% for the green-emitting PtAu2 phosphor and 68.6 cd A-1, 42.5 lm W-1, and 25.1% for the orange-emitting Pt2Au phosphor, which represent the state-of-art for solution-processed OLEDs based on non-iridium phosphors.The combination of ion/ion chemistry with commercially available ion mobility/mass spectrometry systems has allowed rich structural information to be obtained for gaseous protein ions. Recently, the simple modification of such an instrument with an electrospray reagent source has allowed three-dimensional gas-phase interrogation of protein structures through covalent and noncovalent interactions coupled with collision cross section measurements. However, the energetics of these processes have not yet been studied quantitatively. In this work, previously developed Monte Carlo simulations of ion temperatures inside traveling wave ion guides are used to characterize the energetics of the transition state of activated ubiquitin cation/sulfo-benzoyl-HOAt reagent anion long-lived complexes formed via ion/ion reactions. The ΔH‡ and ΔS‡ of major processes observed from collisional activation of long-lived gas-phase ion/ion complexes, namely collision induced unfolding (CIU), covalent bond formation, or neutral loss of the anionic reagent via intramolecular proton transfer, were determined. Covalent bond formation via ion/ion complexes was found to be significantly lower energy compared to unfolding and bond cleavage. selleck chemical The ΔG‡ values of activation of all three processes lie between 55 and 75 kJ/mol, easily accessible with moderate collisional activation. Bond formation is favored over reagent loss at lower activation energies, whereas reagent loss becomes competitive at higher collision energies. Though the ΔG‡ values between CIU of a precursor ion and covalent bond formation of its ion/ion product complex are comparable, our data suggest covalent bond formation does not require extensive isomerization.